Floaty scrolling on the hotbar :: 7 Days to Die Support & Bug Reports

Butikksiden

7 Days to Die

Alle Diskusjoner Skjermbilder Kunstverk Kringkastninger Videoer Nyheter Veiledninger Anmeldelser

7 Days to Die > Support & Bug Reports > Emnedetaljer

MoxxieMox

11 timer siden

Floaty scrolling on the hotbar

Multiple times, To the point it's become a detriment, Is that I will use the scrollwheel to go up or down my hotbar, But it randomly just..Goes in the opposite direction for seemingly no reason. Like I'll try to scroll to my last slot and when I first start it goes back a slot then forwards, then just before it gets to the final slot it does it again

< >

Viser 1–6 av 6 kommentarer

Ensign Toby har 7 Days to Die

9 timer siden

I'm not able to duplicate this behavior...

Might your Scroll Wheel sensitivity (or scroll distance) be set a touch too high?
Try lowering them (a little or a lot) to see if that helps any.

You might be triggering the reversal just by brushing up against the scroll wheel too.

MoxxieMox

8 timer siden

It's not the mouse as far as I can tell. No game has similar issues. And it only happens on the set ticks that my mouse can move on. For example when the mouse wheel clicks into place on it's cycle, It flicks forward a slot then immediately backwards.

Ensign Toby har 7 Days to Die

7 timer siden

When was the last time you thoroughly cleaned your mouse?

Dirt/Finger Grease (yuck)/Lint & Pet Dander accumulate on the wheel rollers over time.
These all would also cause inaccurate positioning of the Scroll Wheel motion sensor...

If you can't disassemble your mouse, you can tilt the Scroll Wheel to view/clean the rollers.
You'll need some narrow (preferably plastic) tools, or some flat toothpicks for best results...

I use plastic dental picks - you should be able to get these at Amazon.

Sist redigert av Ensign Toby; 7 timer siden

MoxxieMox

7 timer siden

Opprinnelig skrevet av Ensign Toby:
When was the last time you thoroughly cleaned your mouse?

Dirt/Finger Grease (yuck)/Lint & Pet Dander accumulate on the wheel rollers over time.
These all would also cause inaccurate positioning of the Scroll Wheel motion sensor...

If you can't disassemble your mouse, you can tilt the Scroll Wheel to view/clean the rollers.
You'll need some narrow (preferably plastic) tools, or some flat toothpicks for best results...

I use plastic dental picks - you should be able to get these at Amazon.

About a month or two ago was the last I cleaned it, I've had it for about 3 years now I believe. It's the steelseries rival 3 wireless