다운로드 위해 구독하기
[P] Ballast, Sleepers and Pipes for Appleby

Tried this twice now. Both times it ends reporting an AI collision (not involving my train so far as I can tell). A bit dissapointing :(

(Mar/2022). Had same problem as others at Appleby. 158 running into wagons down line.

As to the tail lamp. If you shuffle the wagons around so the ballast bag wagons are the rear, you have a tail light.
No QC by the creator.

Only problem is the coal hoppers at appleby

Further to this I edited the scenario to remove the hoppers blocking the line at Appleby which prevented the collision so, once the signal had cleared, I was able to pull forward and stop at the platform as instructed. Was still told I hadn't completed the scenario properly for some reason- perhaps because I started from the editor which, IIRC, is not advised.

Same problem for me running this a couple of times. All goes well until the hold at Appleby then pffft- AI collision. Following the DMU that leaves the siding ahead of you it sets off south only to lam into a couple of hoppers half a mile or so down the main line.

Is no good. AI collision.

nice ride until the stop at appleby signal cab, but can't finish the few meters due to AI collision

Doesnt work, get error at cation point AI collition.

Not good for me. I keep failing the scenario at the caution point. Don't know why. I stop, in plenty of time. I wait and I wait. I press the tab key - Nothing. I pull up 20 feet, try angain and repeat the process. I stop at the "yellow" line on the moving diagram at the bottome of the page; I stop in front of the signal; I stop AT the signal - Nothing - but a complete waste of time that is. I am one of the most postivie people out here - but I can say nothing postive about this scenario at all.
EngineerKenny123

Where are the new particles for the Jubilee from?